Sentro 40 Replacement Handle

Description

The Sentro 40 Replacement Handle contains the handle and the gear. All you have to do is remove a few screws and replace the handle. It will fit perfectly. It is a Sentro 40 original part. You don’t have to order from China and wait a month. Our products usually ship within 24 hours of receiving an order

There are many reasons why your Sentro 40 knitting machine handle may be difficult to turn.

• The worst reason would be if you forced the handle to move when the machine was in the P for panel mode. If you do force it, you could crack the large white circular part. If this happens, the needles will get stuck and the machine will not move. Always make sure your machine is set to T for tube.
• Another reason could be a broken needle
• Or, your machine might need some grease. If you have used your machine a lot, grease may be the answer.
• You could also have a difficulty with the gear attached to the handle. If that is the case, then the Sentro 48 replacement handle is perfect for you.

The only way to know which solution is for you is to try to isolate the reason that the machine is not working properly.

The Sentro 40 Replacement Handle contains the handle and the gear. All you have to do is remove a few screws and replace the handle. It will fit perfectly. It is a Sentro 48 original part. You don’t have to order from China and wait a month. Our products usually ship within 24 hours of receiving an order